(SimpleScreenRecorder reports Warning: Stream was moved to a different source.)īut next time I open SimpleScreenRecorder it has not saved these changes and I have to use pavucontrol again to switch the recording source to the Blue Yeti mic. With pavucontrol still open I started a recording with SimpleScreenRecorder, looking under 'Recording' in pavucontrol I could see the SimpleScreenRecorder entry (while it was recording) and it showed that it was still using the built-in audio card as the recording source, so I just switched the recording source to the Blue Yeti mic.

Using pavucontrol (see answer in Sound Input device (microphone) not working, no need for sudo in this case) I discovered that microphone appears and sound was detected under 'Input Devices' (there is a meter that shows the incoming sound level). This way you adjust the overall volume of the sound recording, no need to raise. I was trying to record using SimpleScreenRecorder but no sound from mic was detected. In order to use the blue yeti microphone properly, there are 5 rules. Presonus recognizes the Yeti, but it won't pick up any sound. I'm sorry, but I had already done all of the above steps. From here you will be able to use the Yeti.

It was detected and appears under 'Audio' in System Settings, it also appears in alsamixer (type alsamixer in konsole). In StudioOne you will set the 'Audio Device' setting in Preferences > Audio Setup to the Aggregate device you set up in your AudioMidi Setup. I would also point out a minor detail as well. Take a second longer to get that breath into your lungs rather than heaving quickly so you can keep talking fast. What I would suggest is to focus on breathing in more softly. Using a Blue Yeti microphone in Kubuntu 20.04. You are close to a mic as you should be, and it's gonna pick up the sound.

Blue yeti mic not picking up sound